Ordering PCBs

This contains the scottyspectrumanalyzer yahoo group backup
Post Reply
piduce
Posts: 5
Joined: Sat Apr 28, 2018 3:30 pm

Ordering PCBs

Post by piduce » Wed Feb 13, 2013 7:37 am

I'm planning on ordering a few sets of PCBs for a friend and I. I've downloaded the gerber files from "Group Buy Spring 2012" in the files section and had a look at them and have a few questions:
  1. Are these the most recent files that we should be using?
  2. There are gerber files for a top and bottom soldermask as well as a top silkscreen layer, but most of the pictures of PCBs I've seen don't have soldermask or silkscreen. Were they left off just to save cost?
  3. I can't find any fabrication notes, so am I correct in assuming the PCBs are all 0.62" thick, 1oz copper, with HAL finish?
Thanks,Cory

Post Reply