Sam Wetterlin's reflection bridge for VNA use

This contains the scottyspectrumanalyzer yahoo group backup
Post Reply
Bruce Beford
Posts: 25
Joined: Sat Apr 28, 2018 6:48 pm

Sam Wetterlin's reflection bridge for VNA use

Post by Bruce Beford » Wed Jun 04, 2014 1:25 am





















Good evening, all.

 

I have a miniboard order from ExpressPCB on it's way for Sam
Wetterlin's Reflection bridge design. I should have them later this week. It's
the "Bridge with Balun plus Beads", shown about half way down his
page here:

 

http://www.wetterlin.org/sam/

 

I will have (2) extra boards from this 3-unit miniboard. I
would prefer to sell these two within the
US , to keep shipping reasonable.
The board cost was 20.90 each, shipped to me. I can ship the spare boards within
the US
for a total of $24.00 each board, PayPal OK.

 

Please contact me off-list, if interested, at beford (at)
myfairpoint dot net

 

Bruce/N1RX






Post Reply