SOLD: Sam Wetterlin's reflection bridge for VNA use

This contains the scottyspectrumanalyzer yahoo group backup
Post Reply
Bruce Beford
Posts: 25
Joined: Sat Apr 28, 2018 6:48 pm

SOLD: Sam Wetterlin's reflection bridge for VNA use

Post by Bruce Beford » Wed Jun 04, 2014 11:17 am























Both of the spare boards have been spoken
for. Thanks for all the interest.

 









From: Bruce Beford
[mailto:beford@...]

Sent: Tuesday, June 03, 2014 9:25
PM

To: ' hpsdr@... ';
'spectrumanalyzer@yahoogroups.com'

Subject: Sam Wetterlin's
reflection bridge for VNA use



 

Good evening, all.

 

I have a miniboard order from ExpressPCB on it's way for Sam
Wetterlin's Reflection bridge design. I should have them later this week. It's
the "Bridge with Balun plus Beads", shown about half way down his
page here:

 

http://www.wetterlin.org/sam/

 

I will have (2) extra boards from this 3-unit miniboard. I
would prefer to sell these two within the
US , to keep shipping reasonable.
The board cost was 20.90 each, shipped to me. I can ship the spare boards
within the US
for a total of $24.00 each board, PayPal OK.

 

Please contact me off-list, if interested, at beford (at)
myfairpoint dot net

 

Bruce/N1RX






Post Reply